Back to Page 1 of Helmet Plate Centres 1881 to 1914 Section

Leicestershire Regiment Brass Order Code HPCS/011 Price: UK£ 15-00 Loyal North Lancashire Brass Order Code HPCS/021 Price: UK£ 15-00 Manchester Regiment Brass Order Code HPCS/017 Price: UK£ 15-00 Middlesex Regiment Brass Order Code HPCS/031 Price: UK£ 15-00 Oxfordshire Light Infantry Brass Order Code HPCS/024 Price: UK£ 15-00 Royal Scots Regiment Brass Order Code HPCS/013 Price: UK£ 15-00 Shropshire Light Infantry Brass Order Code HPCS/027 Price: UK£ 15-00 Somersetshire Light Infantry Brass Order Code HPCS/028 Price: UK£ 15-00 South Wales Borderers Brass Order Code HPCS/005 Price: UK£ 15-00 Suffolk Regiment Brass Order Code HPCS/033 Price: UK£ 15-00 Royal Sussex Regiment Brass Order Code HPCS/004 Price: UK£ 15-00 West Riding Regiment Brass Order Code HPCS/007 Price: UK£ 15-00 West Yorkshire 2nd Volunteer Battalion Plated Order Code HPCS/032 Price: UK£ 15-00 Worcestershire Regiment Brass Order Code HPCS/021 Price: UK£ 15-00 Yorkshire Regiment Brass Order Code HPCS/015 Price: UK£ 15-00

Important Notes Applying to This Section Badges are offered subject to being unsold. Prices quoted are UK Pounds (£ 's) All badges in this section are new, although some may require a degree of polishing depending upon how you wish to display them Images are not to scale Should you wish to make a purchase please refer to our order page for further information. Content Copyright © S.R.S 2007 All rights reserved   Fittings The majority of the helmet plate centres we supply come with two loops attached to the back. There are a few exceptions with three loops however. Figure 4 below shows the reverse of a typical badge , right without its fastening, left with its fastening in place. In the centre is displayed the fastening which is actually a cotter pin. The two loops pass through either the material of the cap, or the holes in the backplate, once through the cotter pin secures the badge in place. All of our badges are supplied with cotter pins as required. An alternative method of fixing helmet plate centres to the tropical helmet was by use of a slider affixed to the reverse of the badge - please note that we do not supply helmet plate centres with the slider method of fixing and that this is for information only. 4 Display Examples 5 A selection of HPC's displayed with standardised backing plates, ( image 5 above ), note the differing crowns, and also the crown for wear with the glengarry cap 6 A selection of HPC's displayed with single Helmet Plate, ( image 6 above ). Helmet Plate comprises one backing plate plus centre, in this example Shropshire Light Infantry.

Back to Page 1 of Helmet Plate Centres 1881 to 1914 Section